BELLOTA HL1100 Manual Del Usuario página 28

• Screw the hose connector (E) into the water
inlet.
NOTE: There is a filter in the connector (E) that
protects from the entry of larger particles that
could affect the operation of your pressure
washer. Do not use the connector without the
filter.
HL1100, HL1400, HL1700
To connect the high pressure hose that is
already connected to your pressure washer,
take the other end of it to the gun; inserting the
silver metal tip of the hose into the hole below
the gun until it clicks. Make sure the hose is
fully connected to the gun by slightly pulling
on it.
To release the hose from the gun, push the
button on the bottom of the gun toward the
trigger (B). The hose will slide out.
(B)
To lock the high pressure gun trigger, make sure
the pressure washer is turned off (0). Point the
high pressure gun away from you and press the
lock button (A) after doing that, pull the trigger
to make sure it is locked and doesn't move.
(A)
To connect the high pressure gun and lance,
make sure the gun is locked and insert the
extension lance (C) into the end of the high
pressure gun in a vertical position, push both at
the same time and rotate them simultaneously
until snap into place. Insert the nozzle into the
end of the extension lance (D) by turning it until
it clicks into place.
(E)
When using the detergent bottle (E), fill it with
a properly formulated detergent or water ratio
cleaner according to the package directions.
The detergent bottle comes with a straw that
sits on top of the thread. If you can't find the
straw, look inside the bottle and attach it to the
cap. Attach the bottle (F) directly onto the end
of the lance until it clicks and twist to lock into
place.
On
Install the garden hose adapter (A). Screw the
adapter (B) onto your garden hose. Connect the
Off
adapter (C) to the filter of your pressure washer.
The water is now connected. To remove the
water hose, simply pull back on the adapter and
it will slide out of the filter.
HL1100
Trigger
24
(C)
(D)
(F)
(E)
(A)
(C)
(C)
(B)