BELLOTA HL1100 Manual Del Usuario página 30

Avoid skin contact with detergents,
particularly eye contact If detergent
gets into your eyes, rinse with clean
water and seek immediate medical
attention.
NOTE: Use only mild and environmentally
friendly detergents. Do not use aggressive
chemicals, abrasive detergents or similar to
avoid harm to your health, the product or the
environment.
Do not connect your pressure washer
to the potable water supply.
Install the garden hose adapter. Screw the
adapter (A) onto your garden hose. Attach the
filter to your pressure washer (B). Slide the
adapter into the filter until it clicks. The water
is now connected to your pressure washer. To
remove the water hose, simply pull back on the
adapter and it will slide out of the filter.
(A)
• Hose reel helps store high pressure hose.
• Pull hose to release from reel (A) for operation.
• Turn crank (B) clockwise to roll up high
pressure hose for storage.
NOTE: Always loosen the full length of the hose
when using your pressure washer to prevent
damage and injury.
Using standin water.
To use standing water instead of running
water, set the standing water container at
least 1 meter high regarding the ground level.
It is necessary to have a safe and adequate
connection (flexible hose).
• Before operating the pressure washer, double
check the high-pressure hose is disconnected.
• Connect the flexible hose coming out of the
standing water container into the pressure
washer inlet. Verify the flow into the pressure
washer is constant.
• Turn on the pressure washer until water
comes out. The pressure washer must be kept
On, with no water flow, 1 minute max.
• Turn OFF the pressure washer and connect
the high-pressure hose. Now, you are ready to
use the pressure washer.
• It is important that the standing water
container is full all the time.
WARNING: Use with stagnant water is only
possible with clean water free of impurities,
debris, leaves or other elements that could clog
the filter at the machine inlet.
(B)
6. Start up
6.1 Turning on
Open the water faucet before turning on the
device.
• Completely untangle the power cord and con-
nect the plug into the power supply. Do not turn
on the pressure washer yet. Make sure it is tur-
ned off to the 0 (OFF) position.
• Unlock the gun button by sliding it and aiming
the gun at a safe area, squeeze and hold the
high pressure gun trigger to release any air tra-
pped in the pressure washer. Release trigger
when water flow is steady allowing air and wa-
(A)
ter to exit gun.
• Turn the switch to the I (ON) position. The en-
gine will start momentarily and then it will stop.
(B)
26
Example