Publicidad
Idiomas disponibles
Idiomas disponibles
the diameter of the pan. However, the bottom of this pan is
suggested to have a minimum of diameter according to the
corresponding cooking zone. To obtain the best efficiency of
your hob, please place the pan in the centre of the cooking
zone.
Base diameter of the pots:
Cooking zone
Minimum (mm)
160mm
140
180mm
140
210mm
160
280mm
230
Flexible zones (only
200
for 50788)
4.2
Using your Induction Hob
ON/OFF control button
4.2.1 To Start Cooking
1. After the hob is connected to the power supply and turned
on.
Press and hold the ON/OFF control button for about 3 seconds
till you hear a "beep" to turn the hob on. Now the hob enters
into Standby mode, all heat setting indicators and Timer setting
indicators shows "-".
2. Place a suitable pan on the cooking zone.
Make sure the bottom of the pan and the surface of the cooking
zone are clean and dry.
3. Set heating level of the cooking zone.
•
There is a separate "-" and "+" heat level control button for
each cooking zone for these models. Set heat setting by
touching "-" or "+" button for the corresponding cooking
zone.
•
Press and hold either of the two buttons, the value will
adjust down or up rapidly, from 0 to 9 in repeat mode.
2) For all models
before adjust heating level, n eed to touch t he heating zone
selection control button to select and activate the cooking zone
you wish to use. When the heat setting indicator of the selected
zone flashing is active, then you could adjust its heat level by
below:
•
Adjust heat setting by sliding the slider control.
A
5 Notes
•
•
Maximum (mm)
160
180
•
210
280
•
400x200
•
4.2.2 To turn off the hob
1. You can turn the cooking zone off by adjusting heat setting
2. You can also turn the whole hob off by pressing ON/OFF
5 Note: If there is a power cut during cooking, all setting will
be cancelled.
5 Note: The cooling fan of induction hob will remain on for
about 1 minute after the hob is turned off.
EN-5
Power Up
After turning the power on, the buzzer of hob beeps once,
all indicators light up for 1 second then go out.
When the hob is in Standby mode, if there is no activity
within 1 minute, the electric hob will turn off automatically,
and the buzzer beeps once.
To turn on the hob, press the ON/OFF control button and
hold for about 3 seconds. To turn it off, press ON/OFF
button again.
The power level can be adjusted from 0 to 9, the default
setting is level 5.
The heat setting indicator of the selected zone flashes when
adjusting. After adjusting, it flashes 5 seconds then stop
flashing, then the setting is confirmed.
to level 0, which indicator shows "-".
control button.
Publicidad
