MAINTENANCE AND
CLEANING
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge.
CLEANING THE COOKING COMPARTMENT WITH THE PYRO CYCLE
Do not touch the oven during the Pyro cycle.
This function enables you to eliminate cooking
spatters using a high temperature. At this
temperature, food residues turn into deposits that can
be easily wiped away with a damp sponge once the
oven has cooled down.
If the oven is installed below a hob, make sure that
all the burners or electric hotplates are switched off
while running the self-cleaning cycle.
Remove all accessories from the oven before
running the Pyro function (including the shelf
guides).
For optimum cleaning results, remove excessive
residuals inside the cavity and clean the inner door
glass before using the Pyro function.
REPLACING THE LAMP
1.
Disconnect the oven from the power supply.
2.
. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3.
Reconnect the oven to the power supply.
WWW
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
Keep children and animals away from the oven
during and after (until the room has finished airing)
running the Pyro cycle.
Then oven has two different pyrolytic cleaning
functions: the complete cycle provides for a thorough
cleaning if the oven is extremely dirty, while the quick
cycle (ECO) is shorter and consumes less energy, thus
making it suitable for use at regular intervals.
Only run the Pyro function if the appliance contains
heavy soiling or gives off bad odours during cooking.
Please note: The oven door cannot be opened while
pyrolytic cleaning is in progress. It will remain locked until the
temperature has returned to an acceptable level.
Ventilate the room during and after the pyrolytic
cleaning cycle (until the room has been completely
aerated).
Please note: Only use 25-40W/230V type E-14, T300°C
incandescent lamps, or 20-40W/230 V type G9, T300°C
halogen lamps. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
Download the Use and Care Guide from
www.aristonchannel.com for more information
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.