Publicidad
Idiomas disponibles
Idiomas disponibles
Type RPC D/PID positioner
5
Industrial Ethernet
5.1
Electrical installation Type RPC with field bus
Applies to the following types:
RPC D ProfiNet
•
RPC D EtherNet I/P
•
RPC D Modbus TCP
•
RPC PID ProfiNet
•
RPC PID EtherNet I/P
•
RPC PID Modbus TCP
•
NOTE!
This document only describes the electrical installation of the RPC positioner type and the determination of the basic settings.
DANGER!
Risk of injury due to power supply.
► Before intervening in the system, switch off the power supply and secure it against being switched on again.
► Observe the applicable accident prevention regulations and safety regulations for electrical devices.
WARNING!
Risk of injury if not properly installed.
► Installation may only be carried out by authorized specialist personnel using suitable tools.
Risk of injury due to unintentional switching on of the system and uncontrolled restart.
► Secure the system against unintentional operation.
► After installation, make sure the system is restarted under controlled conditions.
NOTE!
A shielded Ethernet cable must be used to ensure electromagnetic compatibility (EMC). Earthing
The cable shield on both sides, i.e. on each of the connected devices.
Use a short cable (max. 1 m) with a cross-section of at least 1.5 mm2 for earthing.
5.2
Values
Network speed
10/100 Mbps
Auto-Negotiation Yes
Switch function
Yes
Network diagnostics
MAC-ID Individual identification number, stored in the module and on the outside of the device (see type label)
Device name
Ethernet (factory setting) XXX (name can be changed)
5.3
Objects
The object descriptions are described in a separate document, see download section on www.gfps.com under „Software".
26
Yes, via error telegram
Operating Instructions
Publicidad
