hillvert HT-BC-800 Manual De Instrucciones página 34

and take 10~20 minutes of rest between work sessions. Also try to keep the total amount of
work performed in a single day under 2 hours or less.
Starting engine
WARNING
The cutting head will start rotating upon the engine starts.
1) Feed fuel into the fuel tank and tighten the cap securely.
2) Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding
objects as it will start rotating upon starting of the engine.
3) Push the primer pump several times until overflown fuel flows out in the return tube.
4) Move the choke lever to the closed position.
1 - Choke lever
2 - Closed position
3 - Open position
5) Set the ignition switch to the "start" position.
1 - throttle lever
2 - throttle trigger
3 - Switch
O: Stop position
I: Start position
6) While holding the unit firmly, pull out the starter rope quickly until engine fires.
IMPORTANT: Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can
cause starter failures.