Publicidad
Idiomas disponibles
Idiomas disponibles
en-us
Faults – what to do?
Faults – what to do?
3
F a u l t s – w h a t t o d o ?
B efore you call customer service, use this table to check whether you can rectify the fault yourself.
Temperature differs greatly from the set value.
Displays do not light up.
The power plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates E....
The electronics have detected an error.
A warning signal sounds and the Ú button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food have been placed inside
the appliance.
Display flashes, warning signal sounds and Ú button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food have been placed inside
the appliance.
Display flashes.
The temperature in the freezer compartment was too
warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
24
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the
appliance" on page 14
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature again
on the following day.
Connect the power plug.
Check the fuses.
Check whether the power is on.
Please contact customer service.
~ "Customer service" on page 25
Press Ú button. Alarm is switched off.
Close the appliance door.
Clear the ventilation openings.
Do not exceed maximum freezing capacity.
Press Ú button. Alarm is switched off.
Close the appliance door.
Clear the ventilation openings.
Do not exceed maximum freezing capacity.
After the Ú button is pressed, the warmest tempera-
ture reached in the freezer compartment is displayed
for 5 seconds. Press Ú button. The display stops flash-
ing.
Start the appliance self-test.
~ "Appliance self-test" on page 25
When the program has ended, the appliance switches
over to normal operation.
Publicidad
