Publicidad
Idiomas disponibles
Idiomas disponibles
●
Work in a well-lit, well-ventilated environment.
●
Use the correct wax or polisher for the treatment you are planning
Always hold the polishing machine close to the surface. This way, the machine will work more
efficiently also prevent the polishing liquid from splatter.
1.
Attach the polishing pad to the backing pad, make sure it is centred well
2.
Put amount of wax / polishing liquid on the polishing pad
3.
While keeping the machine switched off, devide the product over the surface to be polished. This
will limit splatter and make sure the product is evenly devided over the surface. When working
large surfaces, split it into smaller parts and treat them one by one.
4.
Put the machine on to the surface, then switch it on at the lowest speed. Continue to spread the
product over the surface to be polished. Hold the machine firmly and make sure you have a good
foothold.
5.
Raise the speed and apply the product in straight tracks. Make sure there is a 50% overlap in
these tracks. Move slowly over the surface until the polishing product has become transparent or
has dried (depending on the type of product you are using).
6.
Clean any remaining product with a microfiber cloth (manually) or a lambs wool polishing pad that
fits with the machine.
●
Remove the battery pack from the device before carrying out any work or transporting it. If the
device is switched on accidentally, there is a danger of injury.
Always wear protective gloves when handling the saw blade 1 be done regularly. This will
ensure a long and reliable service life.
Cleaning
●
Do not spray the appliance with water and do not immerse it in water. Electric shock hazard!
●
Keep clean the ventilation slots, motor housing and handles of the appliance.
●
Use a damp cloth or a brush. Do not use cleaning agents or solvents. You may otherwise irrepara-
bly damage the appliance.
●
Clean the saw blade holder 2 with a brush or by blowing out with compressed air.To do this,
remove the saw blade 17 from the device.
Storage
●
Store the device in a dry location protected from dust, out of the reach of children.
●
Remove the battery pack 9 from the device before storing for extended periods (e.g. over winter).
●
Only store the batty pack partially charged. The battery should be charged to 40 - 60% (two LEDs
in the charge indicator 12 light up) before storing for extended periods.
●
Check the battery pack charge about every 3 months when storing for extended periods and
recharge as necessary.
●
Store the battery pack at temperatures between 50 °F (10 °C) to 77 °F (25 °C). Avoid extreme cold
or heat during storage to prevent the battery pack from losing capacity.
Cleaning / Maintenance
- 14 -
Publicidad
