Publicidad
Idiomas disponibles
Idiomas disponibles
c)
When battery pack is not in use, keep it away from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects, that can make a connection from one terminal to
another. Shorting the battery terminals together may cause burns or a fire.
d)
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
e)
Do not use a battery pack or tool that is damaged or modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
f)
Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or tempera-
ture above 265 °F (130 °C) may cause explosion.
g)
Follow all charging instructions and do not charge the battery pack or tool outside the temperature
range specified in the instructions. Charging improperly or at temperatures outside the specified
range may damage the battery and increase the risk of fire.
6)
Service
a)
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
b)
Never service damaged battery packs. Service of battery packs should only be performed by the
manufacturer or authorized service providers.
Safety Instructions for All Operations
This power tool is intended to function as a polisher. Read all safety warnings, instructions, illustra-
a)
tions and specifications provided with this power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
b)
Operations such as grinding, sanding, wire brushing or cutting-off are not recommended to be
performed with this power tool. Operations for which the power tool was not designed may create
a hazard and cause personal injury.
c)
Do not use accessories which are not specifically designed and recommended by the tool
manufacturer. Just because the accessory can be attached to your power tool, it does not assure
safe operation.
The rated speed of the accessory must be at least equal to the maximum speed marked on the
d)
power tool. Accessories running faster than their rated speed can break and fly apart.
e)
The outside diameter and the thickness of your accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories cannot be adequately guarded or controlled.
f)
Threaded mounting of accessories must match the grinder spindle thread. For accessories mount-
ed by flanges, the arbor hole of the accessory must fit the locating diameter of the flange. Accesso-
ries that do not match the mounting hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
g)
Do not use a damaged accessory. Before each use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for cracks, tear or excess wear, wire brush for loose or
cracked wires. If power tool or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum no-load speed for one
minute. Damaged accessories will normally break apart during this test time.
h)
Wear personal protective equipment. Depending on application, use face shield, safety goggles or
safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and workshop apron
capable of stopping small abrasive or workpiece fragments. The eye protection must be capable
of stopping flying debris generated by various operations. The dust mask or respirator must be
capable of filtrating particles generated by your operation. Prolonged exposure to high intensity
noise may cause hearing loss.
i)
Keep bystanders a safe distance away from work area. Anyone entering the work area must wear
- 03 -
Publicidad
