Look 795 BladeRS Manual página 21

EN
ROUTAGE COMPLET DU 795 Blade RS
NOTE : : Your 795 Blade RS frame is designed
for use with an electronic groupset and is
compatible with most 12-speed and higher
models on the market. To find out more about
compatibility, please contact your nearest LOOK
retailer.
ELECTRONIC CABLE ROUTING (installation video available):
1 - Lay your frame flat on a clean surface to avoid
damaging it.
NOTE: Installation videos available on lookcycle.fr
> ASSISTANCE.
2 - Feed the front derailleur cable up through the
hole in the right-hand side of the seat tube and out
the top. Run the rear derailleur cable through the
hole in the right-hand chainstay (beside the rear
derailleur) and up the seat tube, exiting at the top.
(You can use the pre-routing kit already provided in
the frame to make this easier).
3 - Connect the cables and place the battery in
the seatpost according to the manufacturer's
recommendations, using the adapter provided.
4 - Install the seatpost according to the instructions
(see Seatpost Assembly). If you are unable to insert
the seatpost, the cables may be in the way. Remove
the seatpost and adjust the cables before trying
again.
5 - You will need a workshop stand to continue
assembling the bike. It is important to secure the
frame by the seatpost, tightening to a torque of 7Nm.
The frame must be stripped to allow easy access to
the headset and bottom bracket.
6 - Insert the rear brake hose into the left-hand
chainstay, then over the bottom bracket and up the
down tube. The hose should then exit through the
top of the head tube.
7 - Insert the front brake hose through the left fork
leg and exit through the top of the head tube.
EN