Look 795 BladeRS Manual página 30

EN
BRAKE ASSEMBLY
IMPORTANT : There are two assembly options:
in the first, the hose is connected to the brake
caliper; in the second, the hose is not connected
to the caliper.
1 - Connected hose: insert the rear brake hose
through the chainstay, then feed it through the down
tube and headset.
2 - Disconnected hose: feed the hose through the
headset, down the down tube and out through the
left chainstay.
3 - Remember to slide a 510mm foam tube onto the
rear brake hose.
Your 795 Blade RS is fitted with two bottle mounts,
one on the seat tube and one on the down tube.
Remove the four M5 screws. Install the bottle
holders (please see the relevant product manual),
then grease and tighten the screws to a torque of
4Nm.
Attention : Use only the original screws
!
provided.
NOTE : Your bike is designed for 140/160mm
rear FLAT MOUNT-standard brake calipers.
The chainstay thickness at the rear caliper
attachment point is 25mm.
If you are using 160mm discs, you will need to
use an offset bracket.
HYDRATION
BOTTOM BRACKET
Your bottom bracket is based on the T47 M47
standard, which is 85.5mm wide.
IMPORTANT : We strongly advise you to contact
your nearest LOOK retailer for more information
on compatible bottom brackets.
WHEEL ASSEMBLY
Always follow the manufacturer's assembly
instructions. Our fork legs feature the standard
LOOK conical-head thru axle to eliminate any axial
and radial play (tightening torque 11Nm).
The 795 Blade RS is designed to accommodate tire
widths up to 700x32.
It is important to regularly check and service your
bicycle to ensure your safety and optimize the
lifespan of your product. A poorly maintained bicycle
or components may break or fail and potentially
cause an accident, serious injury or paralysis.
IMPORTANT : : Always grease the thru axle
threads before tightening the wheel in the frame.
MAINTENANCE
For more information on
requirements, please refer to our website
www.lookcycle.com, WARRANTY POLICY >
IMPORTANT INFORMATION.
EN
maintenance