COFFEE DOSE PROGRAMMING
Measures are always programmed using the same but-
ton; any other buttons are ignored. The programmed
amount of brewed coffee can be changed by repeat-
ing the programming.
Lift the pod loading lever until it locks into position to
open the pod fitting compartment.
Put a pod into the pod fitting compartment.
Lower the pod loading lever to close the pod fitting
compartment.
Press and hold one of the two coffee delivery buttons
for at least 3 seconds. The selected key will flash and
the coffee machine will enter the programming mode.
PROGRAMMING THE MACCHINE
Once the desired amount of coffee has been obtained,
stop supply by releasing the button.
If the programmed measure exceeds the maximum
allowed (250 cc) the machine will automatically stop
delivery, the delivery button will blink and the last pro-
grammed measure will be saved in the memory. If
there is a power failure during programming, the last
programmed value remains in the memory. If during a
dose programming, water lack is indicated, the ma-
chine stops the supply and the dose being pro-
grammed won't be saved. Once filled the water tank,
repeat the dose programming procedure.
25
E N