Descargar Imprimir esta página

Infiniton BRUTALE Serie Manual De Instrucciones página 98

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
2. Remove the suspension bracket
- Loosen 2 screws to install the bracket on both sides (M8) (4 posi-
tions left and right) with 10 mm clearance.
- Remove the suspension fixing screw at the rear (M5), pull the sus-
pension backwards (in the direction of the arrow) to remove it.
3. Installing the indoor unit
- Lift the indoor unit, slide it from the front, and place the
suspension installation screw (M8) securely for temporary
suspension.
- Tighten the bracket fixing screws (M5) in 2 positions,
which were removed, as they were before. It is necessary
to avoid misalignment of the indoor unit.
- Tighten the bracket installation screws (M8) securely in 4
positions.
Ceiling installation
1. Selecting the base for the suspension
The suspension base can be a wooden or reinforced concrete structure. It must be firm and reliable to
support the weight of more than 200 kg and able to withstand vibrations for long periods.
2. Fixing the suspension base
Fix the screws of the suspension base as shown on the right or by means of a steel or wooden bracket.
3. Suspending the indoor unit
The indoor unit should be suspended as shown below:
- Adjust the relative positions of the suspension hooks.
- Tighten the nuts and make sure that the hooks are securely connected to the nuts and washers.
- Once the unit is installed, make sure that it is securely fastened and that it does not shake or sway.
Note:
1. To ensure that the drain water drains properly, the unit should be tilted towards the bottom of the unit
after installation is complete.
2. Please make sure that the front side is higher, otherwise it may cause the drainage water to come out
from the air outlet.
4.lInstallation of the drain pipe
The drain pipe should be properly insulated to avoid condensation generation.
Pipes should be installed with a downward slope to allow water drainage.
The pipe must not be raised at any point.
Installation on the ground
The unit must be horizontal or inclined towards the drain pipe when installation is
complete.
98
English
infiniton.es

Publicidad

loading