Publicidad
Idiomas disponibles
Idiomas disponibles
To leave the configuration menu, just press the key of the operating mode you
wish to access.
4.2.3.2
Frequency tuning
When in CHANNEL-FREQUENCY
operating mode, pressing the CH-FR [10]
key switches tuning by channel to tuning
by frequency and vice versa. In the tuning by
frequency mode the instrument becomes a receiver
with a resolution of 10 kHz in the 5 to 862 MHz
band. In this mode you may tune to any signal
within
the
band,
telephone and communications signals. To change tuning simply press the rotary
selector [9] until the digit you want to change is underlined and then turn the rotary
selector [9]. The channel number will appear to the left of the tuning frequency, as long
as it corresponds to an active channel.
Remark : When switching from frequency to channel, if the tuned frequency does not
correspond to any channel, the PROMAX-10 will search for the channel
nearest to this frequency and will stay tuned to this channel. This operation
may take a few moments.
4.2.3.3
CHANNEL-FREQUENCY mode configuration
In CHANNEL-FREQUENCY mode,
pressing the CONFIG key [14] will access the
first page of the configuration menu of the
parameters relative to this mode.
The parameters which may be changed and
their margins are shown in the following table. To
change a given parameter turn the rotary selector
[9] until the field is activated (it will appear shadowed) and then press. The value of the
parameter will be activated and may be changed by turning the rotary selector. When
the value you want appears, press the rotary selector [9] to validate it.
Page 28
including
leakage
USER'S MANUAL. PROMAX-10
Figure 22.- Frequency tuning.
pilots,
Figure 23.- CH-FR configuration.1/2.
IMPORTANT
04/2004
Publicidad
