Publicidad
Idiomas disponibles
Idiomas disponibles
42
MAINTENANCE
1
Remove the old water filter.
Lower or remove
the top left shelf to
allow the water filter
to rotate all the way
down.
Press the push
button to open the
water filter cover.
NOTE: Replacing the water fi lter causes a small
amount of water (around 1 oz. or 25 cc) to drain.
Place a cup under the front end of the water
fi lter cover to collect any leaking water. Hold the
water fi lter upright, once it is removed, to prevent
any remaining water from spilling out of the
water fi lter.
Pull the water filter
downward and pull
out. Make sure to
rotate the filter down
completely before
pulling it out of the
manifold hole.
2
Replace with a new water filter.
Take the new water filter out of its packing
and remove the protective cover from
the o-rings. With water filter tabs in the
horizontal
position,
push the
new water
filter into the
manifold hole
until it stops.
Rotate the water filter
up into position and
close the cover. The
cover will click when
closed correctly.
3
After the water filter is replaced,
dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove
trapped air and contaminants from the
system. Do not dispense the entire 2.5
gallon amount continuously. Depress and
release the dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
4
Water Filter Bypass Plug
Keep the water
filter bypass plug.
You MUST use
the water filter
bypass plug when a
replacement water
filter cartridge is not
available.
CAUTION
DO NOT operate the refrigerator
without the water filter or the water
filter plug installed.
NOTE
To purchase a replacement water filter:
Visit your local dealer or distributor
Web: Find Parts & Accessories from
the Support section of lg.com
Call : 1-800-243-0000 (USA)
1-888-542-2623 (Canada)
Part number of the replacement water
filter: ADQ36006101
Water Filter
Bypass Plug
Publicidad
