Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Icemaker is
The icemaker shutoff (arm/
making too much
sensor) is obstructed.
ice.
Clicking
The defrost control will click
when the automatic defrost
cycle begins and ends.
The thermostat control (or
refrigerator control on some
models) will also click when
cycling on and off.
Rattling
Rattling noises may come from
the flow of refrigerant, the
water line on the back of the
unit, or items stored on top of
or around the refrigerator.
The refrigerator is not resting
solidly on the floor.
The refrigerator with a linear
compressor was jarred while
running.
Whooshing
The evaporator fan motor
is circulating air through
the refrigerator and freezer
compartments.
Air is being forced over the
condenser by the condenser
fan.
Gurgling
Refrigerant is flowing through
the cooling system.
Popping
Contraction and expansion of
the inside walls due to changes
in temperature.
Sizzling
Water dripping on the defrost
heater during a defrost cycle.
Vibrating
If the side or back of the
refrigerator is touching a cabinet
or wall, some of the normal
vibrations may make an audible
sound.
Dripping
Water is running into the drain
pan during the defrost cycle.
Possible Causes
TROUBLESHOOTING
Solutions
Empty the ice bin. If your icemaker is equipped
with an ice shutoff arm, make sure that the arm
moves freely. If your icemaker is equipped with
the electronic ice shutoff sensor, make sure that
there is a clear path between the two sensors.
Reinstall the ice bin and wait 24 hours to confirm
proper operation.
Normal Operation
Normal Operation
The floor is weak or uneven or the leveling legs
need to be adjusted. See the Door Alignment
section.
Normal Operation
Normal Operation
Normal Operation
Normal Operation
Normal Operation
Normal Operation
To eliminate the noise, make sure that the sides
and back cannot vibrate against any wall or
cabinet.
Normal Operation
55
Publicidad
