Descargar Imprimir esta página

Honda UMS425E Manual Del Usuario página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 51
TRANSPORT AND
STORAGE
TRANSPORT
When transporting or carrying your grass trimmer, the engine
must always be stopped.
When carrying your grass trimmer, hold it by the transmission tube
in a balanced position.
If it is to be transported in a vehicle, make sure that it is properly
secured so it cannot move.
It must be positioned so that there is no risk of fuel leakage.
STORAGE
If the machine is not to be used for more than two months, the
following storage precautions should be taken:
- Drain the fuel tank and run the engine to empty the carburettor.
- Remove the spark plug and pour a few drops of oil (same quality
as that used in the engine) into the cylinder.
- Gently pull the recoil starter to distribute the oil in the cylinder and
on the piston. Then reinstall the spark plug.
- Clean the whole machine, paying special attention to plant
residues accumulated around the cutting attachment, in the
engine cooling fins and under the cowlings.
- Using a paint brush, apply a thin film of standard oil over the metal
cutting attachments to prevent corrosion.
- Store the machine in its packaging, in a cool dry place.
- If the machine is to be stored in a vertical position, place it with the
engine at the bottom so that it will not topple over.
USING THE AFTER A STORAGE PERIOD
1. Remove the spark plug, check that it is clean and that the
electrode gap is correct. Pull the starter several times.
2. We recommend that the spark plug be screwed down as far as
possible by hand until finger tight ; then use a plug spanner to
tighten it by an extra 1/8 or 1/4 turn.
3. Check the level and condition of the engine oil.
4. Fill the fuel tank and start the engine.
NOTE: If the cylinder has been coated with oil, the engine will
smoke on start-up. This is normal.
B3 D3
D4
D7
SAFETY
FUEL STORAGE
NOTE:
• Petrol will oxidize and deteriorate in storage.
Old petrol will cause hard starting, and it leaves gum deposits that
clog the fuel system. If the petrol in your mower deteriorates
during storage, you may need to have the carburetor and other
fuel system components serviced or replaced.
• Ensure that you use containers
or drums specifically designed
for hydrocarbons [1]. This will
prevent polluting the fuel
through the dissolution of the
container walls, which will lead
to poor functioning of the engine.
• Store the fuel in a dark place, in
a room at constant temperature
(avoid garden sheds).
• The warranty does not cover a blocked carburetor or valves
jammed by old or polluted fuel.
• The quality of unleaded petrol alters very quickly (2 to 3 weeks in
some cases). Do not use fuel more than 1 month old. Store the
absolute minimum required for your monthly consumption.
ACCESSORIES
CURRENT PARTS,CONSUMABLES
Various accessories are supplied with the machine or are available
as options.
Mowing and clearing
Current parts
Consumables
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
yourgrass trimmer's model and type.
[1]
UMS425E
LEET
72560-VL6-R11
Standard
17211-Z0H-000
Air filter
31915-Z0H-003
Spark plug
28462-ZM3-003
Recoil starter
08221-888-010MP
Engine oil
A2 C4
C13 D6
SAFETY
9 EN

Publicidad

loading