Gude GH 2000 Traducción Del Manual Original página 22

ENGLISH
To set the stepless rotary control
thermostat to the desired room temperature, please
proceed as follows:
1. Set the rotary control
2. Let the unit run until the desired room tempera-
ture is reached.
3. Slowly turn the control dial
unit switches off.
The unit now regulates the room temperature auto-
matically via the room thermostat by automatically
switching off when the set temperature is exceeded
and switching on again when the temperature falls
below this set temperature. To do this, heating level 1
or 2 must be set on function controller
Note
The desired room temperature should be higher than
the current room temperature.
Note
The operating control light
thermostat is set to a temperature above the room
temperature via the control dial
time the ventilation or a heating level is set on the
function control . If the unit is off, i.e. the function
2
control is set to position 0, the operating control
2
light does not light up.
3
Switch off the unit
1. Set the stepless rotary control
thermostat to min.
2. Set the function control
3. Let the fan run for 2-3 minutes to cool down
the unit.
4. Switch the unit off by setting the function
control to 0.
2
5. Unplug the mains cable from the mains socket.
6. Allow the unit to cool down completely.
22
of the room
1
to max.
1
back until the
1
.
2
lights up when the
3
and at the same
1
of the room
1
to ventilation
2
Troubleshooting
Problem Cause
Unit has no power
supply
Unit, mains cable
Unit without
or mains plug is
function
defective
The overheating
protection has been
triggered
No heating level set
The room temp. is
above the tempe-
rature set on the
thermostat.
The safety thermo-
Unit does not
stat has tripped
heat
The overheating
protection has been
triggered
The anti-tilt
protection has been
triggered
Reduced air Air inlet and outlet
flow not free
Solution
Check the socket
Plug in the mains
plug correctly
Check house fuse
Check mains cable
and plug
Contact customer
service or a spe-
cialist
Switch off the
appliance and
disconnect the
mains plug.
Contact the
customer service or
a specialist
Set heating level
Increase the ther-
mostat temperature
Switch off the unit
and disconnect the
mains plug.
Eliminate the cause
of overheating
before restarting
the appliance.
Switch off the unit
and disconnect the
mains plug.
Contact customer
service or a spe-
cialist
Ensure that the
unit is positioned
vertically and is not
exposed to extreme
inclination
Clean and observe
minimum distances