cecotec bolero DRESSCODE 7300 Inverter A Manual De Instrucciones página 79

Connection between the washing machine connector and the water supply hose.
Align the curved part of the hose and the washer connector (inlet valve) on the back of
-
the product as shown in figure 7.
Tighten the compression nut by turning clockwise.
-
Connection between a screw tap and the water supply hose
- Screw tap and water supply hose.
Align the other end of the water supply hose and the threaded tap and tighten the
-
compression nut tightly by turning clockwise. Check figure 8 for reference.
Drain hose
Note
- Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
-
There are two ways to place the end of the drain hose:
1. In a drainpipe. It is recommended to use a vertical tube. Fig. 9
2. In a sink's drainpipe, over the trap. Fig. 10
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If drain hose is too long,
do not force it into washing machine as it will cause abnormal noises.
Acoustic sponges (depending on model)
Warning
Be sure to assemble the acoustic sponges, as they can reduce the noise caused by the
washing machine while it is running.
1. Place a soft material, such as foam or towels, between the base of the washing machine
and the floor for protection.
2. Gently lift the washing machine on one side and stick the longer sponges on the longer
bottom edges of the washing machine on its base. Do the same to adhere the shorter
sponges to the shorter bottom edges. Fig. 25
BOLERO DRESSCODE 7300/8300/9300/10300
ENGLISH
79