Descargar Imprimir esta página

Troy-Bilt TB25PS Manual Del Operador página 26

Motosierra de pértiga
Ocultar thumbs Ver también para TB25PS:

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
monoxide exhaust fumes can be lethal in a confined area.
WARNING:
and the unit must be in a stable position when pulling the starter rope (Fig. 12).
STARTING INSTRUCTIONS
NOTE: To prevent the throttle control from being squeezed accidentally, this unit has a throttle
lockout. The throttle control cannot be squeezed unless the throttle lockout is also engaged.
NOTE: There is no need to turn the unit on. The On/Off switch is in the On ( I ) position at all times (Fig. 10).
Before Starting the Unit
1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
3. Put the shoulder strap over the operator's head and onto the left shoulder (Fig. 8).
Starting the Unit
NOTE: DO NOT squeeze the throttle control (Fig. 10) until step 6.
1. Slowly press and release the primer bulb 10 times (Fig. 11).
2. Flip the choke lever clockwise until it clicks (Fig. 11).
3. Crouch in the starting position (Fig. 12).
4. Pull the starter rope with a controlled and steady motion until the unit starts (Fig. 12).
5. Idle the engine for 30 seconds.
6. Press and hold the throttle lockout (Fig. 10). Squeeze the throttle control as needed for operation
(Fig. 10).
IF... the engine does not start after pulling the starter rope 10 times, repeat the starting procedure.
IF... the engine is already warm: Press and hold the throttle lockout. Squeeze and hold the throttle
control. Pull the starter rope with a controlled and steady motion until the unit starts.
After Starting the Unit
1. Snap the shoulder strap clip onto the shoulder strap loop. Adjust the shoulder strap to fit the
operator. Refer to Assembling and Using the Shoulder Strap.
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the Off (O) position until the engine comes to a complete stop
(Fig. 10).
STARTING AND STOPPING
Operate this unit only in a well-ventilated outdoor area. Carbon
Avoid accidentally starting the unit. To avoid serious injury, the operator
26

Publicidad

loading