Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not operate the unit faster than the speed needed to do the job. Do not run the unit
at high speed when not in use.
•
Do not force the unit, especially near the end of a cut. It will do a better, safer job when
used at the intended rate.
•
Always turn the unit off when operation is delayed or when carrying the unit from one
location to another. Make sure all moving parts come to a complete stop.
•
Before setting the unit down, always turn the unit off and wait for all moving parts to
come to a complete stop.
•
If the unit strikes or becomes entangled with a foreign object, stop the unit
immediately. Check for damage. If damaged, do not restart or operate the unit until it is
repaired. Do not operate the unit with loose or damaged parts.
•
Use only original equipment manufacturer (OEM) replacement parts and accessories for
this unit. These are available from your authorized service dealer. Use of any other parts
or accessories could lead to serious injury to the user, or damage to the unit, and void
the warranty.
•
Keep the unit clean. Carefully remove vegetation and other debris that could block
moving parts.
•
To reduce fire hazard, replace a faulty muffler and spark arrestor. Keep the engine and
muffler free from grass, leaves, excessive grease or carbon build up.
•
If the unit starts to vibrate abnormally, stop the unit immediately. Inspect the unit for
the cause of the vibration. Vibration is generally an indicator of trouble.
POLE SAW SAFETY
DANGER:
moving blades. Contact with moving blades will result in serious personal injury.
WARNING:
lines (Fig. A). This unit is not designed to provide protection from electric shock if
contact is made with electric lines. Keep at least 50 feet (15 m) away from all
power lines. Refer to local regulations for specific information about safe
distances. Always make sure the area is clear of electric lines and the operator is
in a safe position before operating the unit. Contact with, or use near, power
lines may cause serious injury or electric shock resulting in death.
•
Make sure the saw chain is not in contact with anything before starting the unit.
•
When carrying the unit, hold it away from the body, with the guide bar positioned to
the rear. Cover the guide bar and saw chain with the scabbard when carrying the unit.
•
Keep the work area clean. Cluttered areas invite injuries. Do not start cutting until the
work area is clear and free from obstructions. Make sure there is secure footing and a
planned retreat path from falling trees or branches.
•
Do not stand directly under limbs being trimmed (Fig. A). Always take a position out of
the path of falling debris.
Keep all body parts (hands, feet, face, etc.) away from
Do not operate the unit near electrical cables or power
7
Publicidad
