Publicidad
Idiomas disponibles
Idiomas disponibles
IOMM
Single-Cable Connection
Start, for a single-cable connection, by disconnecting the end of
the cable from the termination block located at the very bottom of
the charger. Then, unplug the communications, starting from
the bottom power module, until the module to be replaced has
been disconnected. (Figure 28)
NOTE
The ribbon cable has a red edging to denote Pin 1.
Always, when facing the module, insert the connectors
so that the cable red line is on the left.
Webasto Charging Systems, Inc.
Figure 27 Single-Cable Connection
ProCore Edge North America
Page 47 of 69 31241-03-0202
Publicidad
