Silvercrest SSTMC 600 A1 Instrucciones De Uso página 11

4) Press the lid 2 firmly down onto the blender 3. Close the lid 2 by turning
it clockwise to position
pouring spout on the blender 3 is closed. The motor cannot start until the
lid 2 is fitted flush.
Fig. 1
5) Press the measuring cap 1 into the lid as far as the stop.
6) Place the completely filled and closed blender 3 onto the motor block 6
with the handle to the right. Make sure that the arrow
points to the
3 slightly back and forth if it does not fit properly into place immediately.
The motor cannot start until the blender 3 is fitted flush to the motor unit.
Selecting the speed setting
Once the blender 3 is filled and sitting completely closed on the motor block 6,
you can switch on the appliance.
Set the switch 5 to ...
■ Level 1 – 3
for liquids or soft foodstuffs, for mixing, blending and stirring
■
Level 3 – 5
for more solid foods or for chopping
■ Level P (pulse function)
for short, powerful impulse operation, e.g. for crushing ice cubes or when
cleaning. To prevent overloading the motor, the switch 5 does not lock in this
position. Therefore, hold the switch 5 in this position for short periods only.
NOTE
Fill the blender 3 with ice cubes up to the 250 ml mark at the maximum.
►
Otherwise, the ice cubes will not be crushed optimally.
■ 8 │ GB │ IE
until it audibly engages (see Fig. 2). Ensure that the
Fig. 2
marking on the motor block 6. Turn the blender attachment
on the blender 3
SSTMC 600 A1