IPC MLC-C Manual De Instrucciones página 21

Mount the accessories only
when the appliance is off.
Connect the high pressure
hose to the high pressure
washer (fig. 2C) and to the
lance (fig. 3).
Information
The high pressure washer
must be operated with clean
water
!
Danger.
Dirty or sandy water, or
water containing corrosive
chemicals or solvents seriously damage the high pressure
washer.
Failure to respect the above absolves the Manufacturer of all
liability and represents negligent use of the product.
Information
Respect the instructions provided by the water
utility company.
Current regulations specify that the appliance may not be con-
nected to the drinking water supply unless a suitable system
separator is fitted.
Use a suitable EN 12729 type BA system separator.
Water passing through a system separator is no longer classi-
fied as drinking water.
!
Warning
Do not connect the machine to a drinking water container.
!
Danger
Never suck up liquids containing solvents or acids in the pure
state,
for example petrol, paint solvents or diesel.
The spray mist from the lance is highly inflammable, explosive
and poisonous.
Never use acetone, acids in the pure state and solvents as they
seriously damage the high pressure washer.
CONNECTING TO THE MAINS ELECTRICITY SUPPLY
The high pressure washer must be connected to the mains
electricity supply by a qualified electrician able to operate in
respect of current standards and regulations.
Check that the mains voltage corresponds to the voltage of the
high pressure washer as given on the rating plate.
!
Danger
- The power cable must be protected from accidental crushing.
- Do not use the high pressure washer if the power cable is
damaged.
- The following fundamental rules must be observed when using
any electrical equipment:
- do not touch the appliance with wet hands or feet ;
- do not use the equipment in bare feet or with unsuitable
clothing;
- do not pull the power cable or the appliance itself to unplug
the plug from the mains socket.
English
(for high pressure washers with a power rating of less than 3
kW fitted with a plug).
The high pressure washer is classified as a Class I appliance
for protection against electric shock.
Failure to respect the above absolves the Manufacturer of
all liability and represents negligent use of the product.
CLOTHING AND EQUIPMENT
FIG. 3
You are recommended to wear overalls to reduce the risk of
injury caused by involuntary contact with the high pressure jet.
- 21 -
Wear safety shoes with non-slip soles.
Wear protective goggles or visor and safety
garments.