Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and care
GB
Switching the appliance off
Disconnect your appliance from the electricity supply before
carrying out any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external parts and
the rubber seals may be cleaned using a sponge which
has been soaked in lukewarm water and neutral soap.
Use specialised products for the removal of stubborn
stains. After cleaning, rinse well and dry thoroughly. Do
not use abrasive powders or corrosive substances.
• The hob grids, burner caps, flame spreader rings and
burners may be removed to make cleaning easier; wash
them in hot water and non-abrasive detergent, making
sure all burnt-on residue is removed before drying them
thoroughly.
• Clean the terminal part of the flame failure safety devices*
frequently.
• The inside of the oven should ideally be cleaned after
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
• Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry thoroughly
with a soft cloth. Do not use rough abrasive material or
sharp metal scrapers as these could scratch the surface
and cause the glass to crack.
• The accessories can be washed like everyday crockery,
and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on the
appliance.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.
Replacing the light bulb
! Do not use the oven lamp as/for ambient lighting.
32
To replace the oven light bulb:
1. Remove the glass cover of
the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
Wattage 25 W, cap E 14.
3. Replace the glass cover
(see diagram).
Gas tap maintenance
Over time, the valves may become jammed or difficult to
turn. If this occurs, the valve must be replaced.
! This procedure must be performed by a qualified technician
who has been authorised by the manufacturer.
Publicidad
