Cherubini BLUE WAVE RX Serie Instrucciones página 24

Press the UP-
button
UP
DOWN
Press the buttons quickly according to the sequence indicated
DOWN
Press the buttons quickly according to the sequence indicated.
The motor will carry out a movement to confirm your settings.
Most of the command sequences have three or six distinct steps, at the end of which the
motor indicates if the step has been concluded positively or not, by turning in different
ways. This section is provided to demonstrate the motor indications. The buttons must be
pressed for at least 0,5 seconds as shown in the sequence, without taking more than 1
second between one step and the next. If more than 1 second is taken, the command is
not accepted and the sequence must be repeated.
Command sequence example:
As we can see from the example, when the sequence ends positively, the motor carries
out one long rotation.
If the motor does not carry out any rotation, this means that the sequence has failed. In
this case the sequence must be carried out again from the start.
Attention! If the sequence requires a repetition of the same commands (Up+Up/
Down+Down), an interposition of the Stop position could be necessary depending
on the type of switch in use.
KEY TO SYMBOLS
DOWN
UP DOWN
UP DOWN
COMMAND SEQUENCES EXAMPLE
Press the
DOWN-button
UP
24
up
down
short motor
rotation in one
direction
long motor
rotation in
other direction
UP UP