Cherubini BLUE WAVE RX Serie Instrucciones página 25

MOTOR PROGRAMMING FROM THE WHITE WIRE
PLEASE NOTE. If the motor is programmed from the white wire without first having
memorised at least one remote control, the remote function will be deactivated
automatically (to reactivate it, see page 23 - ACTIVATION/DEACTIVATION OF THE
REMOTE CONTROL MOTOR FUNCTION).
Motor programming from the white wire is active until the limit switches have been
programmed. Once the limit switches have been programmed, the possibility of
programming the motor from the white wire remains enabled for a maximum time of 5
minutes; this to enable the changing of certain functions such as the adjustment of the
closing force, the middle position, etc.
Each time that the motor power supply is disconnected and the motor is then powered
up again, the programming function from the white wire is reactivated (always with a
maximum duration of 5 minutes).
NOTE FOR OPERATION FROM THE BUTTON SWITCH
The motor automatically recognizes the switch-type (with 1 or 2 buttons) and sets the
proper operational mode. Following the automatic recognition and after the wire setting,
if required the motor changes the association of the switch buttons to adapt them to the
correct drive direction (Up - Down). At this point, if the drive direction does not match
with the buttons, the motor resets the proper association upon the first complete Up/
Down cycle. During this cycle the motor performs a technical stop and then automatically
starts back up.
25