Stahlwille MANOSKOP 755R/1 Instrucciones Breves página 9

755R/1 | 755 Setting
The release torque is set using a torque wrench test unit.
Adjustments are made by turning the adjustment spindle at
the end of the handle of the torque wrench using an Allen
key 3 mm. Turn to the left for higher release values and to
the right for lower release values.
Continue making these adjustments until the test unit
display the desired value after several trial procedures
have been carried out. The adjustment spindle is secured to
prevent any accidental adjustments.
755R/1 This wrench is equipped with a built-in, non-
switchable ratchet and has a 1/4" outer square drive.
755 Change of tools
All tool inserts 9 x 12 mm (755/4; 755/10) or 14 x 18 mm
(755/20; 755/30) fit this torque wrench.
Press down locking pin when inserting a new tool. Make
sure under all conditions that lockingpin is arested!
Tools may be inserted turned by 180° for anticlockwise
tightening.
Just depress locking pin with a mandril when removing the
tool.
9
EN