Storage, Delivery And Unpacking; Installation; Placement - Talsa F14s Manual De Instrucciones

HYDRAULIC PISTON FILLERS F14/25/35/50

4. Storage, delivery and unpacking

 ALWAYS keep the machine upright, even
while in its packaging.
 NEVER stack machines even if they are in
their original packaging.
 NEVER place heavy objects on top of the
machines or its packaging.

5. Installation

(Aprox. duration: 30 minutes)

5.1 Placement

Electrical Hazard!
 The electrical installation of the enclosure
must provide a thermal protection device
(MCB) and leakage (differential),
conforming to the specifications of each
machine. A qualified electrician must adjust
these safety devices to the specifications of
your particular machine. (see section
(Technical Specifications)
 Do not use the machine in wet locations.
 Do not lift the machine more than
necessary, it could collapse.
 In order to move the F50 model, two people
are required.

Do not store the machine in cold places (i.e. refrigerated storage house). Persistent low temperatures can cause damages in the machine.
© Talsabell s.a. All rights reserved.
The machine is delivered on a pallet protected either by cardboard packaging (F14/25/35) or
wooden crate (F50). We use only recyclable packaging and ask that you please recycle these
materials.
Remove the packaging and thoroughly inspect the machine upon delivery. Should you note any
damage to the machine, retain all packing materials and promptly notify the carrier. The
transport company is solely responsible for any damage to the machine during transit.
If the machine is found to be in satisfactory condition, follow the instructions in section
(POSITIONING THE MACHINE) in order to safely convey it to a suitable work area. Your needs
will determine the most appropriate location for the machine.
The machine should be placed in the most appropriate place, according to the demands and
needs of use. For a good, prolonged operation, the machine should be placed in a sufficiently
ventilated area, avoiding lack of air circulation. The workplace should be clean, free from
obstacles and have a horizontal and anti-slip surface. Observe a passage area around the
machine of 1 meter to proceed to use, clean and maintenance thereof.
To move the machine to the desired location:
■ ALWAYS firmly hold the carrying handle and the lid handle to move the machine. NEVER
use the knee lever to move the machine!
■ Tilt the machine so that it is balanced on its wheels and may be rolled into place.
■ ALWAYS place the machine on a flat, level surface. Should the machine wobble, adjust the
3:
anti-vibration legs until it is perfectly level and stable.
■ The machine should be positioned so that the power plug is easily accessible to the operator.
EN - 10
INSTALLATION AND OPERATING MANUAL
5.1
Unpacking
Easy moving
V-1.3 last revision: 07/2018