General Cleaning Recommendations; Recommended Cleaning Intervals; Stainless Steel Care - Talsa F14s Manual De Instrucciones

HYDRAULIC PISTON FILLERS F14/25/35/50

7.2 General cleaning recommendations

Steps
Superficial cleaning & residue removal
Extensive cleaning
Rinsing
Inspection
Disinfecting
Rinsing
Drying
Conservation

7.3 Recommended cleaning intervals

Interval Area to be cleaned
Daily Lid, lid gasket, tank and piston
screw
Weekly Piston, piston seals and piston
screw gasket
Every two weeks
Machine body, bottom of the
machine
NOTE: The above cleaning intervals are suggested for companies with just one work shift. The machine should be cleaned more frequently if it is used for multiple shifts each day.

7.4 Stainless steel care

Never use aggressive cleaners with stainless steel such as bleach or similar chlorine derivatives products. If you have used it, never leave acting, rinse immediately
with plenty of water and dry thoroughly.
It is uncommon, but possible, that small traces of rust or oxidation points may be observed on the machine. This may be due to:
■ Welding impurities.
■ Food fragments adhering to the surface.
■ Pits resulting from use of aggressive cleaners such as bleach or similar chlorine derivatives products.
■ Moisture that remains after cleaning with water. ALWAYS wipe dry all components that have been cleaned.
To remove these rust spots simply use a liquid stripper with a cloth, or clean with Scotch Brite.
© Talsabell s.a. All rights reserved.
Products Tools
Spatula
Mild detergent Brush, bucket
Warm water Sponge, bucket
Disinfectants; NEVER use Sponge, cleaning cloth
bleach
Potable water Sponge, bucket
Cleaning cloth
Lubricating oil Cleaning cloth
Product
Mild detergent, warm water
Mild detergent, warm water
Mild detergent, warm water
Observations
Promptly after use.
Allow the product to work approximately 15 minutes.
The water should be 40 to 50°C (100 to 120°F)
Visually examine all critical components, especially those subject to stress and wear.
Disinfect after completing all other cleaning operations.
ALWAYS rinse the machine thoroughly after using detergents and disinfectants.
Be sure to completely dry all cleaned components.
Only external machine parts.
Tools Observations
Sponge, cleaning cloth Remove contamination from the piston center screw using, if
necessary, a brush to prevent the accumulation of waste.
Sponge, cleaning cloth To remove the piston follow the instructions detailed above.
Sponge, cleaning cloth
EN - 20
INSTALLATION AND OPERATING MANUAL
V-1.3 last revision: 07/2018