Holmatro HNC 1536 N Serie Manual página 26

EN
/i
Object
General
Hydraulic couplers
Dust caps
Hydraulic hoses
Cutter
1. Holmatro dealer maintenance.
8.4 Maintenance activities
8.4.1 General
• Check the tool for damage and leaks. If the tool does not work properly and/or leaks, have it
repaired by an Holmatro Certified Technician.
8.4.2 Hydraulic couplers
• Check the couplers for damage. Have a Holmatro Certified Technician replace damaged couplers.
• Clean the coupler with luke warm water and a mild soap solution.
• Dry the couplers.
• High-Flow couplers:
- Lubricate the end of the coupler with hydraulic oil or inject WD-40.
- Lubricate the retainer ring by injecting WD-40 underneath the ring.
- Check the locking by pulling the hoses apart with a normal manual effort. The couplers must not
slip.
- Disconnect the couplers by turning the retainer ring.
• Connect and disconnect the couplers a few times to improve the internal lubrication of the locking
system.
8.4.3 Dust caps
• Check the dust caps for damage. Replace damaged dust caps.
• Clean the dust caps with running water. Dry the dust cap and treat it with preservative oil.
8.4.4 Hydraulic hoses
• Clean the hose with luke warm water and a mild soap solution.
26
Action
Check
Clean, lubricate
Clean
Clean
Lubricate, check
916.219.553_003
Time interval
x
x
x
x
x x
x
x
x
x
x
HNC