osann Eno360 Manual Del Usuario página 29

1 . Set the child car seat to seat position 1 and rotate it so that it faces seat position R in a
rear-facing orientation.
2 . Set the age of your child on the RotationControl knob.
3 . Press the two lateral Isofi x connector buttons in order to extend the length of the Isofi x con-
nectors.
4 . Guide the Isofi x connectors onto the Isofi x anchor points on the seat of the vehicle and ensure
that they lock into position.
5 . Push the child car seat in until it rests securely against the backrest of the seat of the vehicle.
Ensure that both Isofi x indicators are showing green.
6 . Take the top tether out of the storage bag and extend it to its full length.
7 . The top tether strap must be guided through the top tether guide (slot, marked orange in
illustration) on the child car seat from the inside to the outside. Ideally, use the guide towards
the interior of your car to ensure rotation to the car door for easy entry and exit.
8 . Clip the top tether onto the hook provided in your car (e.g. on the back of the car seat or in the
boot. Please consult your car manual for this).
9 . Tighten the top tether until the display on the top tether turns green.
10 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
11 . Unfasten the belt buckle on the child car seat and place the belts on the outside of the seat.
12 . Put your child in the child car seat.
13 . Adjust the height of the headrest as described above.
14 . Fasten the belt buckle again until you hear a click.
15 . Pull the front adjustment strap to tighten the belts. Ensure that the straps are not twisted.
16 . Turn the seat into the rear-facing position. Check that the child car seat is locked in this
position.
- 29 -
EN