Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DELETING A REMOTE CONTROL
If you are in programming mode exit pressing the MENU button until -- appears. Press the DOWN
(RADIO) button for more than 2 seconds. Until the display shows the word "rad" (radio), then release the
button
1. Press the DOWN (RADIO) button until the LED lights up (about 3 seconds)
2. Press the button of the remote control to be deleted within 7 seconds, holding it down until the KEY
LED goes out. Release the remote control button
3. About 1 second after the button is released, the KEY LED starts to flash
4. Confirm the deletion by pressing the DOWN (RADIO) button
5. If the deletion has been successful, KEY LED will give one long flash
N.B If no commands are given for 7 seconds, the receiver automatically quits the programming mode
CLEARING THE ENTIRE RECEIVER MEMORY
If you are in programming mode exit pressing the MENU button until -- appears. Press the DOWN (RADIO)
button for more than 2 seconds. Until the display shows the word "rad" (radio), then release the button
1. Press the DOWN (RADIO) button and hold it down until the LED lights up (about 3 seconds) and then
goes out (about 3 seconds). Release the button
2. About 1 second after the button is released, the KEY LED starts to flash
3. Press the button on the receiver as the LED flashes for the third time
4. If the deletion has been successful, the KEY LED will give one long flash
REMOTE MEMORISATION OF A REMOTE CONTROL WITH A REMOTE CONTROL ALREADY MEMORISED
A transmitter can be memorised without accessing the receiver. The user needs to have a transmitter
memorised previously, after which the procedure is as described below. The remote copy procedure
must be carried out in the area served by the receiver.
1. Press the button of the new remote control to be memorised, holding it down for at least 5 seconds
2. Press the button of the old remote control to be copied (if phase 1 has been successful, the
automation system will not respond)
3. Press the button of the new remote control to be memorised, holding it down for at least 3 seconds
4. Press the button of the old remote control to be copied, holding it down for at least 3 seconds, to
confirm and quit the programming mode
N.B If no commands are given for 7 seconds, the receiver automatically quits the programming mode
4.5 - Customising the system - Basic Menu
If necessary, users may select a basic menu which allows
modification of the control unit's basic parameters. To select the
basic menu proceed as described below.
WARNING: to be certain of accessing the NORMAL OPERATION
--
UP
DOWN
MENU
Press the MENU button for 1
second to access the basic
menu.
26
tCL
UP
DOWN
MENU
After accessing the BASIC
MENU, press the + and –
buttons to scroll through the
functions.
display state, the starting point for accessing the basic menu,
press the MENU button twice.
Exampling of modifying a BASIC MENU parameter
20
UP
DOWN
MENU
To access the value modification
function, press the MENU
button for 1 second, until the
value starts to flash quickly.
>3s ►
►
0,5s
0,5s
>3s
>3s
>3s
1s +
1s +
>3s
>5s
>3s
>3s
>3s
19
UP
DOWN
MENU
Press the + and – buttons to to
modify the value.
Publicidad
