Federal Signal Global G-STR Instrucciones De Instalación Y Mantenimiento página 21

All manuals and user guides at all-guides.com
LIGHT HAZARD: To be an effective warning device, the beacon
produces bright light that can be hazardous to your eyesight
when viewed at close range. Do not stare directly into the
beacon at close range or permanent damage to your eyesight
may occur.
BURN HAZARD: The strobe tube gets hot enough to burn you.
Always allow the strobe to cool before handling it.
DO NOT TOUCH STROBE TUBES WITH BARE HANDS: Oil
deposits on the glass portion of the tube can cause the glass
to fracture during use. If you are unsure whether the glass
portion has been handled without gloves, clean the glass
using a soft cloth and isopropyl alcohol before installing
the lamp.
STATIC SENSITIVE DEVICE: The circuitry of the beacon can be
damaged by an electrostatic discharge (ESD). Always follow
anti-static procedures while servicing the beacon.
Tool and replacement part needed: 1.5 mm A/F hexagon key, and
Federal Signal strobe tube part No. K8107177.
To replace the strobe tube:
1.
Disconnect power to the beacon.
2. Use the hexagon key to unscrew the set screw on the housing
one full turn.
3.
Remove the cover from the housing by turning the cover
counter-clockwise. If the strobe lens will not unscrew, back
out the set screw a few additional turns.
4.
Remove the strobe tube from the socket by pulling it up on
the base using a gentle rocking motion.
Model G-STR Global Series Strobe Beacon
Installation and Maintenance Instructions
21