SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 12

EN
2.6.2.Upgrading a TaHoma ready installation into a TaHoma switch installation
To add TaHoma switch into a TaHoma ready installation, and then upgrade the installation into a TaHoma switch
installation, follow the instructions on the TaHoma pro application.
2.6.3.Erasing the memory of the drive (reset to original configuration)
NOTICE
This reset deletes all paired control points, end limit settings, advanced settings and resets the drive's favourite
position (my).
Press and hold the PROG button on the drive until its LED blinks orange and the slats
briefly move up and down 3 times.
➔ All the settings are erased. The drive is reset to its original configuration.
➔ The drive is in programming mode during 3 min, and its LED blinks orange.
Resume the commissioning procedure (Refer to Commissioning).
3.USE AND MAINTENANCE
NOTICE
This drive does not require any maintenance operations.
The way to control a Zigbee motorised product is different depending on the solution present in the installation: TaHoma
switch solution or TaHoma ready solution.
Please refer to the corresponding section according to the solution.
3.1.Use with TaHoma switch solution
3.1.1.Use with TaHoma application
To control the motorised product in connected mode, you need to access and use TaHoma application, you must have a
compatible phone or mobile device and access to the internet.
The application is downloadable for free from Apple Store platforms and Google Play Store on Apple or Android
compatible mobile devices. This compatibility is the one indicated in the description of the application on the corresponding
Store.
The software version of the TaHoma application may be updated from time to time to add new features and services.
1] Download TaHoma application if it is not yet installed on the smartphone.
2] Launch the application and follow the instructions to control the motorised
product.
3.1.2.Use with a control point
3.1.2.1. Up and Down buttons
▪ Briefly press the Up or Down button on the control point to tilt the slats to
the up or lower position of tilting.
▪ Press and hold the Up or Down button on the control point until the slats
reach the desired position of tilting. The movement stops when the button is
released.
12
1]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
TILT ONLY 50 WF ZIGBEE
™
2]