SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 9

TILT ONLY 50 WF ZIGBEE
1] Press and hold the PROG button on the drive until the slats move up and
down briefly and its LED blinks orange: the drive is in programming mode
during 3 min.
2] Briefly press the PROG button on the control point: the slats move up and
down briefly.
g The drive can now be controlled using the control point.
2.5.6.Creating a network with TaHoma ready: add control points and drives in
the installation
▪ To add a new single-channel or multichannel control point to the drive or to delete one of its paired control points:
refer to the control point instruction guide.
▪ To pair additional drives: follow the same procedure of commissioning with a new control point for each drive and
refer to the control point instruction guide to have them share the same network.
2.5.7.Modifying the direction of rotation with a control point
CAUTION
• This procedure cannot be performed on multiple drives at the same time.
• The drive must be set and paired to the control point.
NOTICE
Keep the control point close to the drive during the whole procedure.
1] Press and hold the PROG button on the control point until the slats move up
and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The slats move up and down after a few seconds.
3] Press the my button on the control point until the slats move up and down:
ð The direction of rotation has been modified.
4] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
5] Press the Up button on the control point to check the direction of rotation.
2.5.8.Readjusting the end limits with a control point
CAUTION
• This procedure cannot be performed on multiple drives at the same time.
• The drive must be set and paired to the control point.
NOTICE
Both end limits can be readjusted: either only one of them, or both at the same time.
2.5.8.1. Readjusting the upper end limit
NOTICE
Keep the control point close to the drive during the whole procedure.
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
1]
2] 3]
4] 5]
EN
9