SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 4

EN
2.1.Assembly
2.1.1.Preparing the drive
1] Cut the shaft to the length required.
2] Position the headrail and shaft adapters on the drive.
2.1.2.Fitting the drive inside the headrail
1] Insert the drive in the headrail.
CAUTION
Take care not to cut the power supply cable on the edges of the headrail when
introducing the drive.
2] Slide the shafts to the end stops of the drive's shaft adaptors.
NOTICE
For optimal radio reception, the drive antenna should be kept straight and
should be positioned outside of headrail (if used).
NOTICE
It can be installed in a central or lateral position.
2.2.Wiring
WARNING
• To ensure electrical safety, this Class III drive must be powered by a «SELV» voltage source (Safety Extra Low
Voltage).
• For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance.
• Improper using battery pack may cause overheat, fire, explosion, resulting in serious injury or death.
• Do not expose the drive or battery to excessive temperatures.
• There is a risk if terminals of the battery-operated drive or battery being short circuited by metal objects.
• Ensure battery is fully charged prior to installation on site.
Connect the battery or power supply to the drive's power supply cable.
4
1]
2]
1]
2]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
TILT ONLY 50 WF ZIGBEE