SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 14

EN
Programming or modifying the favourite position (my)
NOTICE
Only one favourite position (my) is permitted.
1] Move the slats to the desired favourite position using the Up or Down
button.
2] Briefly press the my button to stop the slats.
3] Press and hold the my button until the slats briefly move up and down:
g The desired favourite position (my) is programmed and green LED blinks
5 times.
Using the favourite position (my)
▪ If a favourite position (my) is programmed, briefly press the my button on the
control point twice in succession: the slats first move to the lower end limit
and then to the favourite position (my).
3.3.Tips and advice on operation
3.3.1.Questions about the product?
Observations
The motorised product does not work. The drive battery is low and requires
NOTICE
If the motorised product still does not work, contact a drive and home automation professional.
4.TECHNICAL DATA
Frequency bands and maximum power used
Power supply
Operating temperature
Index protection rating
Safety level
Torque
Speed
Minimum distance between two end limits
Maximum distance between two end limits
Maximum number of associated controls
NOTICE
For additional information on the technical data for this drive contact your Somfy representative.
Please separate storage cells and batteries from other types of waste and recycle them via the local collection
facility.
14
Possible causes
charge.
The control point battery is low.
2.4 GHz - 2.4835 GHz e.r.p <63mW [USA, Australia, Canada]
12 Vdc SELV
0°C - 60°C
IP30 (For indoor use only)
Class III
1 N·m
5-15 rpm
1/8 turn
5 turns
12
1]
2]
Solutions
Plug in the charger.
Check the battery and replace if
necessary.
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
TILT ONLY 50 WF ZIGBEE
3]
x 2 =