Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Locking screw
To adjust flame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold panel
graphics.
Simmer Set Screw
38 English
After the flames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks, and
close the oven door.
1. Rotate a knob to "LO" position and
remove the knob from the valve shaft
while the flame is lit.
2. Carefully push the screw driver into
the C chanel of the valve, until it hits
the simmer set screw. Make sure the
screwdriver flathead is seated into the set
screw groove.
3. Rotate valve set screw clockwise to
decrease "LO" setting flame output, or
rotate set screw counter clockwise to
increase "LO" setting flame output.
Publicidad
