Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fed service center for assistance.
GENERAL MAINTENANCE
Keep the generator in a clean and dry environment
where it is not exposed to dust, dirt, moisture, or corrosi-
ve vapors. Do not allow the cooling air slots in the gene-
rator to become clogged with foreign material such as
leaves, etc. Do not use a garden hose to clean the gene-
rator. Water entering the fuel system or other internal
parts of the unit can cause problems that will decrease
the life of the generator.
To clean the unit:
- Use a soft bristle brush and/or vacuum cleaner to
loosen
and remove dirt and debris.
- Clean air vents with low pressure air that does not
exceed 25 psi.
- Wipe the exterior surfaces of the generator with a
damp cloth.
CHECKING/CLEANING AIR FILTER
See Figure 10.
For proper performance and long life, keep air filter
clean.
- Turn the knob on the bottom of air the filter cover to
release.
-Remove cover and set aside.
- Remove the filter element.
- If the filter element is dirty, clean with warm, soapy
water. Rinse and let dry.
www.ducsonpower.com
- Apply a light coat of engine lubricant to the element,
then squeeze it out.
- Replace the element in the air filter unit.
- Replace the air filter cover and latch to secure.
NOTE: Do not run the generator without the air filter.
Rapid engine wear will result.
CHANGING ENGINE LUBRICANT
See Figure 11.
- Remove the oil cap/dipstick.
- Place a container underneath the oil drain plug to
collect
used lubricant as it drains.
- Unscrew the oil drain plug and remove.
- Allow lubricant to drain completely.
NOTE: Drain the lubricant while the engine is still warm
but not hot. Warm lubricant will drain quickly and more
completely.
WARNING:
Do not change engine lubricant while it is hot. Accidental
contact with hot engine lubricant could result in serious
burns.
- Reinstall the oil drain plug and tighten securely.
- Refill with lubricant following the instructions in the
Checking/ Adding Lubricant section. For amount of
lubricant needed to refill, see Product Specifications
earlier in this manual or the accompanying engine
manual, if applicable.
- Reinstall the oil cap/dipstick.
Pag: 20
Publicidad
