Publicidad
Idiomas disponibles
Idiomas disponibles
60
PROGRAMMING MODE - SETUP MODE
28. How to set shut down time after UE
Unbalance Error (UE) occurs when washer cannot balance the load within the selected drop counts.
can be used to set the time for maintaining the UE status before shutting down the cycle.
Enter setup mode.
You will see LqC1
Press the Hot button.
Press the Warm or the Cold button until
in the display.
Press the Start button.
Press the Warm or the Cold button until
in the display.
Press the Start button.
Display default shut down time.
Press Warm or Cold button to select time between
0~10.
(0 : Permanent standby, 1~10 : Shut down after
selected time)
To restart after Permanent standby, redistribute load
and press Start button.
Press the Start button.
The machine sets up the shut down time, then
advances to the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the Hot button twice.
Button
Display
appears
appears
Publicidad
