Rohde KE Serie Manual De Instrucciones página 34

4. Start-up
4.1. Delivery & unpacking of the kiln
The ROHDE Toploader will usually be delivered on a pallet by a freight-forwarding agent. Immediately after delivery
check the packaging for any visible damage. Should you detect any damage, unpack the pallet together with the
driver and check the goods again for damage. If you detect any damage, please enter details on the delivery note
and let the driver countersign your remarks. Keep one copy of the complaint for yourself. Inform the freight
forwarding agency immediately of the damage. Complaints submitted at a later date cannot be taken into
consideration.
4.2. Disposal of the packing material
Contribute to a clean environment by disposing of wood, cardboard and plastic packaging material in your nearest
waste disposal plant. For further information concerning the disposal of packaging material please contact your
dealer or community council.
4.3. Installation environment & operating location
When selecting a suitable place for your kiln, please note the following guidelines and prepare the kiln environment
accordingly:
• The kiln is not intended for outdoor installation outside of closed rooms.
• Place the kiln on an even surface.
• The distance to the walls should be at least 50 cm on each side.
• The floor, ceiling insulation, walls, dividing walls, panelling, etc. must be made of flame resistant material.
•
Make sure that the kiln environment can be properly ventilated. Otherwise a ventilation system must be
installed. Please consult a qualified ventilation specialist.
• Permissible ambient conditions:
− Permissible ambient temperature = -5 °C to +30 °C
− Relative humidity
− Firing chamber atmosphere
4.4. Assembly of the kiln
4.4.1. Supplied accessories
Check the enclosed accessories first:
Model Supplied accessories
Cordierite blocks
Cordierite base plate
KE-B Panel for mounting the controller and fixing screws
Chimney stone (not included with the automatic exhaust air option)
Sheet metal plates for leveling the kiln (KE 105 B – KE 210 B)
Cordierite blocks
KE-N
KE-S
Exhaust air socket and fixing screws
KE-S+
KE-SH
Panel for mounting the controller and fixing screws
= less than 80% (non-condensing)
= oxidising
32 / 166 - EN -
Quantity
4 pieces
1 piece
1 piece
1 piece
4 pieces
4 pieces
1 piece
1 piece