Rumble Tuff BREEZE Manual Del Usuario página 16

9. Troubleshooting
Problem Solu�on
No power • Make sure it's the correct power adaptor for Rumble
Tuff model.
• Try different wall outlet, if it's s�ll not working,
please call Rumble Tuff customer service at
Toll-Free:(855)228-8388.
Interrup�on of During normal opera�on of your Rumble Tuff electric
breast pump, if you experience an interrup�on of
electrical service
electrical service, due to a power outage or other
factors, try the following:
• Unplug the AC/DC Adapter from the electrical outlet
and wait for 5 seconds.
• Plug the AC/DC Adapter back into the electrical
outlet.
• If the problem persists, try a different electrical
outlet.
Radio frequency This equipment generates, uses, and can radiate radio
frequency energy. If not installed properly and used in
energy
accordance with the instruc�ons, it may cause harmful
interference with other devices in the vicinity. Try the
following steps if interference occurs:
• Reorient or relocate the device receiving interference.
• Increase the distance between the equipment.
• Connect the equipment to an outlet on a circuit
different from that which the other device(s) are
connected.
• Consult the manufacturer or a field service
technician of the device receiving interference for
help.
• Please understand that there is no guarantee that
interference will not occur.
Pump doesn't If the Power Symbol flashes
and hear 4 Beeps(under Alarm ON), contact the local
run when power
DME dealer/retailer you purchased the unit from.
is "on"
28
or you see " "
No suc�on • Make sure the tubing is securely a�ached to the
pump and the Collec�on Kits.
or low suc�on
• If problem happens in one side of the collec�on
bo�le, try to switch the tubing to different vacuum
inlet to see if the problem is now switched to the
different collec�on bo�le.
• If yes, the problem may be at the pump unit.
Contact Technical Support for further assistance
• If not, follow the following steps to troubleshoot
the problem in the Expression Collec�on Combo
Kit.
• Make sure the Expression Collec�on Combo Kit is
assembled correctly. (see pages 13 – 16)
• Center your nipple in the Flange and make sure
there is a complete seal between the Flange and
your skin Press the Diaphragm firmly into the Cup
and make sure there is no gap. (see page 15 step
5)
• Check the Membrane Valve and make sure that it
is properly sealed and securely seated. (see page
14)
• Inspect the Membrane and Valve very closely for
tears or warping. This component is cri�cal to
achieve proper suc�on; even the �niest tear will
adversely affect pump performance. If damaged,
replace the Membrane Valve with one of the spare
valves provided with your Rumble Tuff Breeze.
Breast milk If breast milk doesn't appear to be draining fast
enough into the Collec�on Bo�le, reduce the suc�on
buildup in the
se�ng on your Electric Breast Pump to allow the milk
Breastshield Body
to drain before gradually increasing the suc�on to
the original se�ng.
The breast pump Contact the Rumble Tuff Customer Service.
generates only
constant vacuum
instead of
sucking cycles
Unplug the pump unit from the power source and
The pump unit's
turn it off. Dry off the exterior of the pump unit.
exterior got wet
9. Troubleshooting
29