Publicidad
Idiomas disponibles
Idiomas disponibles
−
Renew the harness protective tape.
Page 6 - figure 1
−
Connect the black wire of the power harness* to the vehicle earthing point -arrow-.
continued for all vehicles:
Page 6 - figure 2
Note
The connectors -1-, -2- and -4- are designed such that they can only be connected into the socket on the controller
-3- in one position.
−
Connect the sensor connect -1- according to its numbering into the associated sockets "1" to "4" on the controller*
-3-, until they „click" into the fixed position.
−
Connect the power harness connector -2- into the associated socket on the controller -3-, until it „clicks" into the
fixed position.
−
Connect the buzzer connector -4- into the associated "BUZ" socket on the controller -3-, until it „clicks" into the fixed
position.
−
Set up the parking distance control system.
⇒
1.7 Setting up the parking distance control
1.6.2 5-door vehicles
Page 6 - figure 3
−
Connect the black wire of the power harness* to the vehicle earthing point -arrow-.
Page 6 - figure 4
−
Route the red wire in the power harness* from the control unit along the left hand side of the vehicle, starting from
the tailgate.
−
Secure the wire to the existing harness using cable ties* -arrows-.
Page 7 - figure 1
−
Disconnect the connector -A- from -B-.
−
Starting at the light connector, unwind approximately 50 mm of the vehicle harness protective tape.
−
Cut the vehicle's blue/red wire (Pin 8 on connector).
−
Crimp one end of the blue/red wire -1- in a duraseal connector* -2-.
−
Crimp the free end of the blue/red wire -4- and the red wire -3- of the the power harness together in the duraseal
connector -2-.
−
Seal the duraseal connector -2- with the hot air blower from the wiring harness repair set -VAS 1978-.
−
Return the anti-backout device -A- to connector -B- to the locked position.
−
Renew the harness protective tape.
Page 7 - Fig. 2
Note
The connectors -1-, -2- and -4- are designed such that they can only be connected into the socket on the controller
-3- in one position.
−
Connect the sensor connect -1- according to its numbering into the associated sockets "1" to "4" on the controller*
-3-, until they perceptibly engage.
−
Connect the power harness connector -2- into the associated socket on the controller -3-, until it „clicks" into the fixed position.
−
Connect the buzzer connector -4- into the associated "BUZ" socket on the controller -3-, until it „clicks" into the fixed
position.
−
Set up the parking distance control system.
⇒
1.7 Setting up the parking distance control
1.7
Setting up the parking distance control
Page 7 - figure 3
Note
◆
When setting up cars with a removable towhook, this must be fitted.
◆
To avoid errors, do not use a metal wall (e.g. a garage door) and avoid shiny white walls.
◆
Do not enter the sensor detection area -A- during setup.
−
To set up the parking distance control system reverse the car until it is 50 cm from a wall.
−
Switch off the engine.
28
*please refer to the set contents
Publicidad
