Atlas Copco LSS 84 Instrucciones De Producto página 11

LSS 84
This can be solved by lubricating with oil (a few drops), running the machine
for 5-10 seconds and wiping off excess oil with a cloth. Do this before longer
standstills.
Lubrication
The motor is lubricated using the built-in oil chamber in the motor casing. The
oil chamber is filled by pouring oil in the hole for the plug – the oil level should
not lie above the head of the screw upon topping up.
The oil supply is adjusted by the screw which must be slightly tightened if the
oil supply rate is too small. To check the oil supply, hold a piece of paper in
front of the exhaust holes in the motor casing while the motor is running. If the
oil supply rate is sufficient, oil stains will be formed on the paper.
Check daily before using the tool that the oil chamber is filled to the correct
level.
When making the regular overhaul of the tool, the throttle, governor and ball
bearings should be lubricated with grease.
The front ball bearing should be greased through the nipple at intervals of 20
work shifts if the tool is used with normal frequency.
Lubricating guide
Use lubricants of good quality. The oils and greases listed in the lubrication ta-
ble are examples of lubricants that can be recommended.
Brand
BP
Castrol
Esso
Q8
Mobil
Shell
Texaco
Atlas Copco
Useful information
EN
General purpose
Bearings
Energrease LS-EP2
Spheerol EP L2
Beacon 2
Rembrandt EP2
Mobilplex 48
Alvania EP2
Multifak EP2
No 4210 2255 00
© Atlas Copco Industrial Technique AB - 9836 971301 01
Safety and operating instructions
Air lubrication
Energol RD-E46
RD Oil 100
Arox EP 68
Chopin 46
Almo oil 525
Torcula 68
RD Lube32
11