Publicidad
Idiomas disponibles
Idiomas disponibles
U
I
S
4.3
Managing the appliance with the remote control
It is possible to select the various modes by pressing the
buttons ( see Description of machine functioning paragraph).
The remote control provided has been designed to be
functional and resistant, however it must be handled
cautiously.
Avoid:
-
leaving it exposed to rain, pouring liquids on it or
dropping it into water
-
hitting it or dropping it on hard surfaces
-
leaving it under the sun
Battery insertion
Only CR2012 3V dry lithium batteries must be used
(supplied). Used batteries must be handed over to
the specific collection areas as arranged by the Local
Authorities for this type of waste.
In order to insert the batteries, open the specific cover
4.4
Description of machine functioning
General start-up and management
In order to manage the appliance using the remote control
and the touch-screen, the main switch on the electrical
power supply line must be turned on (its exact position will
be best known by the technician who installed the appliance)
or the power supply plug must be connected to the system
socket.
Once such operations have been performed, it is possible
to manage the system using the symbols on the touch-
Key/Display
Operation
The buttons on the remote and the keys on the touch-screen display have the same function.
When the appliance is on, 3 digits on the display will show the room temperature.
•
It is possible to adjust the setpoint between 16 and 31°C.
Avoid setting the temperature too low or too high as, in addition to being unhealthy, it's a waste of
energy.
-
placing obstacles between the remote and the
appliance while using it.
In addition:
-
if there are other appliances using remote controls in
the room (TV, radios, stereos, etc.), interferences may
occur
-
electronic or fluorescent lamps can interfere with
communication between the remote and the appliance
-
remove the battery if not using the remote for a long
time.
in the bottom part of the remote. The battery must be
inserted respecting polarity. Once the battery is inserted,
close the cover.
screen or the remote control. In order to transmit commands
to the internal unit, the top part of the remote must point
towards the display of said internal unit. The reception of
the command is confirmed by a beep and by the display.
The maximum distance for the remote control to work is
approximately 8 metres.
TROUBLESHOOTING
EN
45
Publicidad
