Troubleshooting: Location And Repair Of Faults; Petrol Motor - ENAR CRENA 22 Manual De Instrucciones

9

TROUBLESHOOTING: LOCATION AND REPAIR OF FAULTS

9.1 PETROL MOTOR

Will not start:
en
No power:
CRENA 52*, 63*
28
- There is fuel in the tank but the igniter plug will not spark
•
There is electricity in the high-tension cable
➢
There is electricity in the high-tension cable
➢
Spark plug shorts out
➢
Carbon deposits on igniter plug
➢
Shortcircuit due to faulty insulation of the igniter plug
➢
Incorrect separation between electrodes
•
There is no electricity in the high-tension cable
➢
Shortcircuit of stop button switch
➢
Faulty ignition coil
➢
Faulty insulation or shortcircuit of condenser
➢
Ignition coil broken or shortcircuiting
•
Compaction satisfactory
➢
Incorrect fuel
➢
Water or dust has got inside
➢
Faulty air filter
- There is fuel in the tank and the igniter plug sparks correctly
•
Incorrect compaction
➢
Intake or exhaust valve is stuck or faulty
➢
Piston ring or cylinder is worn
➢
Cylinder head or spark plug not adjusted properly
➢
Head gasket or gasket on spark plug faulty
•
The clutch is blocked making the vibrator turn when attempting to start
•
There is no fuel in the carburettor
➢
Fuel tank is empty
➢
The fuel cock is not open properly
➢
Fuel filter is blocked
➢
Air vent in the tank cover is blocked
➢
Air retained in the fuel pipe
➢
Carburettor intake valve is stuck
- Insufficient power
•
Compaction normal and no fault observed in the starting mechanism
➢
Faulty air filter
➢
Carbon deposits in the cylinder
➢
Fuel level in the carburettor is incorrect
•
Inadequate compaction
➢ (See "Incorrect compaction" above)
•
Compaction is correct but startup is deficient
➢
There is water in the fuel
➢
The spark plug is dirty
➢
The ignition coil is faulty
➢
The ignition coil often shortcircuits
REVERSIBLE VIBRATORY PLATE COMPACTOR