Husqvarna PG 830 Propane Manual Del Usuario página 11

4. Turn the emergency stop button clockwise to
disengage.
Safety instructions for maintenance
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is damaged or does not
work correctly. Do the safety checks, maintenance
and the servicing as given in this manual. All other
maintenance work must be done by an approved
service agent.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To remove the product from the
package
WARNING:
pallet carefully and safely. The product is
heavy and can cause serious injury if it falls.
• Make sure that all items that is shown in the product
overview, are included. Refer to
right side on page 3 . Speak to your Husqvarna
dealer if an item is missing or damaged before you
move the product from the pallet.
• Remove all package straps and wheel chocks.
• Make sure that the area is clear and that you have
sufficient space to move the product.
• Make sure that there is no risk that you or the
product can fall.
• Use lifting equipment or ramps to move the product
from the pallet. The product is heavy. Move the
product safely. Refer to
down a ramp on page 27 .
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Put on necessary personal protective equipment.
Personal protective equipment on page 8 .
Refer to
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
schedule on page 19 .
5. Make sure that the product is assembled correctly
and is not damaged.
2023 - 003 - 04.04.2023
Operation
Before you operate the
Move the product from the
Product overview,
To move the product up and
Maintenance
• Installation and repair of the supply system for
propane must be done only by approved servicing
personnel for propane systems.
• Stop the product when you replace the diamond
tools. Turn the ignition key to 0 and push the
emergency stop button.
• Do the inspection and/or maintenance with the
engine stopped.
• Do the maintenance to make sure that the product
operates correctly. Refer to
on page 19 .
6. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
on page 27 .
7. Make sure that there are diamond tools on the tool
plates and that the diamond tools and tool plates are
tightly attached.
8. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 14 .
9. Adjust the handle and the handlebar to an applicable
operation height. Refer to
the handlebar on page 15 .
10. Make sure that the battery is connected. Refer to
connect and disconnect the battery on page 15 .
11. Make sure that the propane tank is connected. Refer
To connect and disconnect the propane tank on
to
page 15 .
12. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
To engage and disengage the support
frame
The product has a support frame that is used to tilt the
product rearward. Also, the support frame is used as a
suspension device to hang the dust extractor hose.
Maintenance schedule
Transportation
To
To adjust the handle and
To
11