Husqvarna PG 830 Propane Manual Del Usuario página 20

Maintenance
Do a check of the connection between chassis and grinding head.
To clean the product
WARNING:
protective equipment (PPE) when you clean
this product.
CAUTION:
decreases the performance of the product
and can cause the engine to become too
hot.
• Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
• Do not use chemicals to clean the product.
• Do not clean electrical components with water.
• Do not clean the carbon monoxide detector with
water or use water near the detector. The filter in
the carbon monoxide detector is sensitive.
• Always clean all the equipment at the end of the
work day. Clean the components at the bottom
surface of the grinding head with a high-pressure
washer.
CAUTION:
pressure washer directly at seals or
connection points.
To clean the battery
CAUTION:
with water.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery with a soft and dry
cloth.
20
Use correct personal
A blocked air intake
Do not point the high-
Do not clean the battery
Daily
To clean the cooling fins
1. Clean the oil cooling fins with a brush or with
compressed air and vaccum cleaner..
To do a general inspection
• Make sure that nuts and screws are tight.
• Make sure that the head locks are tight. If it
is necessary, tighten the head locks and use
®
LOCTITE 680 threadlocker.
Each
12
Week- Every
month
ly 100 h
s or
250 h
*
2023 - 003 - 04.04.2023