Husqvarna PG 830 Propane Manual Del Usuario página 13

tools. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the diamond tools. The
dust extractor will decrease the dust that can
cause health problems.
CAUTION:
always have the same number and type of
diamonds. The height of the diamonds must
be the same on all grinding discs.
1. Turn the ON/OFF switch (A) on the control panel to
0. The LED adjacent to the ON/OFF switch goes off.
2. Push the emergency stop button (B) on the control
panel.
3. Set the handle in servicing position. Refer to
adjust the handle and the handlebar on page 15 .
4. If weights are installed, adjust the weights to a
rearward position. Refer to
5. Engage the support frame. Refer to
disengage the support frame on page 11 .
2023 - 003 - 04.04.2023
Use the dust extractor
All the grinding discs must
B
STOP
Disc
560 790 1010
A
To
Weights on page 18 .
To engage and
6. Hold the handlebar and with one foot on the support
frame tilt the product rearward. Tilt the product until
the handlebar is on the floor.
WARNING:
product is in a stable position before you
replace the diamond tools.
7. Put on protective gloves.
8. Turn the tool plate (C) to the right or to the left to
unlock the tool plate from the grinding disc.
9. Pull the tool plate straight out (D) to remove the tool
plate from the grinding disc.
10. Use a hammer to remove the diamond tools from the
tool plate. Hit the outer edge of the diamond tools to
move them in the direction of the center.
11. Attach new diamond tools to the tool plate with a soft
hit of the hammer outward.
Make sure that the
C
D
13